Toyota T100 1996 Service Manual page 1940

BO−20
1996 TOYOTA T100 (RM449U)
BODY − WINDSHIELD
REMOVAL
1. REMOVE INNER REAR VIEW MIRROR
2. REMOVE SUN VISORS AND HOLDERS
3. REMOVE ASSIST GRIPS
4. REMOVE FRONT PILLAR GARNISHES
5. REMOVE WIPER ARMS
6. REMOVE COWL LOUVER
7. REMOVE WEATHERSTRIP
8. REMOVE WINDSHIELD OUTSIDE MOULDING
Remove the 4 screws and the moulding.
N05942
9. REMOVE WINDSHIELD OUTSIDE MOULDING
Using a knife, cut off the moulding, as shown.
NOTICE:
Do not damage the body with the knife.
N12567
10. REMOVE WINDSHIELD GLASS
(a) Push piano wire through between the body and glass
from the interior.
(b) Tie both wire ends to a wooden block or similar object.
HINT:
Apply adhesive tape to the outer surface to keep the surface
from being scratched.
NOTICE:
When separating the glass, take care not to damage the
BO5232
paint and interior and exterior ornaments. To prevent
scratching the safety pad when removing the windshield,
place a plastic sheet between the piano wire and safety
pad.
(c) Cut the adhesive by pulling the piano wire around it.
(d) Remove the glass.
NOTICE:
Leave as much of the adhesive on the body as possible
when cutting off the glass.
BO1689
BO0EA−02