SA-4
SUSPENSION AND AXLE (STATION WAGON) - WHEEL ALIGNMENT
FRONT WHEEL ALIGNMENT
1.
INSTALL WHEEL ALIGNMENT EQUIPMENT
Follow the specific instructions of the equipment
manufacturer.
2.
INSPECT CAMBER AND STEERING AXIS INCLINATION
Camber:
1°00' ± 45' (1.00° ± 0.75°)
Cross camber:
30' or less (0.50° or less)
Steering axis inclination:
13°00' ± 45' (13.00° ± 0.75°)
If the steering axis inclination is not as specified after
camber have been correctly adjusted, recheck the steer-
ing knuckle and front wheel for bending or looseness.
3.
INSPECT CASTER
3°00' ± 1° (3.00° ± 1°)
If caster is not as specified, inspect and replace damaged
or worn parts.
4.
INSPECT TOE-IN
Toe-in (total):
If toe-in is not specification, adjust by tie rod.
5.
ADJUST TOE-IN
(a)
Loosen the clamp bolts and nuts.
(b)
Adjust toe-in to the correct value by turning the tie rod.
(c)
Insure that the lengths of the tie rod ends are the same.
(d)
Torque the tie rod clamp bolts and nuts.
Torque:
37 Nm (375 kgf-cm, 27 ftlbf)