Toyota T100 1996 Service Manual page 1879

BE−44
Warning Light
Ignition
Switch
Battery
OFF
ON
Warning Light
Ignition
Switch
Battery
1996 TOYOTA T100 (RM449U)
BODY ELECTRICAL
20.
ON
(a)
OFF
(b)
If operation is not as specified, replace the switch.
N06136
21.
(a)
(b)
(c)
If the warning light does not light up, test the bulb.
BE1217
22.
(a)
(b)
If operation is not as specified, replace the switch.
N07797
23.
(a)
(b)
(c)
If the warning light does not light up, inspect the bulb or wire har-
ness.
N13155
24.
(a)
ON
OFF (b)
If operation is not as specified, replace the seat belt inner.
N06137
− COMBINATION METER
INSPECT PARKING BRAKE SWITCH
Check that there is continuity between terminals with the
switch ON (switch pin released).
Check that there is no continuity between terminals with
the switch OFF (switch pin pushed in).
INSPECT WASHER LEVEL WARNING LIGHT
Disconnect the connectors from the level warning switch
and parking brake switch.
Connect terminals on the wire harness side connector of
the level warning switch connector.
Remove the CHARGE fuse and turn the ignition switch
ON, check that the warning light come on.
INSPECT WASHER LEVEL SWITCH
Check that there is no continuity between terminals with
the switch OFF (float up).
Check that there is continuity between terminals with the
switch ON (float down).
INSPECT SEAT BELT WARNING LIGHT
Remove the integration relay from the junction block
No.1.
Ground terminal 9 on the junction block side connector.
Turn the ignition switch ON, check that the warning light
lights up.
INSPECT BUCKLE SWITCH CONTINUITY
Check that there is continuity between terminals on the
switch side connector with the switch ON (belt unfas-
tened).
Check that there is no continuity between terminals on the
switch side connector with the switch OFF (belt fastened).