Toyota T100 1996 Service Manual page 1943

Adhesive
1996 TOYOTA T100 (RM449U)
BODY
10.
(a)
(b)
BO2821
(c)
(d)
NOTICE:
Take care not to drive the vehicle during the time described
in the chart below.
BO3986
11.
(a)
(b)
12.
Coat the glass with adhesive at the mouldig installation area.
Adhesive
BO3671
13.
Place the moulding onto the body and tap it by hand.
14.
15.
16.
17.
18.
19.
N12568
20.
− WINDSHIELD
INSTALL GLASS
Position the glass so that the reference marks are lined
up, and press in gently along the rim.
Using a spatula, apply adhesive on the glass rim.
Use a scraper to remove any excess or protruding adhe-
sive.
Fasten glass securely until the adhesive sets.
Temperature
35°C (95 °F)
20°C (68 °F)
5°C (41 °F)
INSPECT FOR LEAKS AND REPAIR
Perform a leak test after the hardening time has elapsed.
Seal any leak with sealant.
Part No. 08833−00030 or equivalent
APPLY ADHESIVE AT MOULDING INSTALLATION
AREA
Part No. 08833−00030 or equivalent
INSTALL WINDSHIELD UPPER MOULDING
INSTALL WINDSHIELD OUTSIDE MOULDING
INSTALL WEATHERSTRIP
INSTALL COWL LOUVER
INSTALL WIPER ARMS
Torque: 20 N·m (204 kgf·cm, 15 ft·lbf)
INSTALL FRONT PILLAR GARNISHES
INSTALL ASSIST GRIPS
INSTALL SUN VISORS AND HOLDERS
Minimum time prior to drive of the vehicle
1.5 hours
5 hours
24 hours
BO−23