Toyota T100 1996 Service Manual page 1917

BE−82
1996 TOYOTA T100 (RM449U)
BODY ELECTRICAL
Antenna Nut
BE4671
BE5781
BE5780
Twist
BE4674
− ANTENNA
REPLACEMENT
1. REMOVE ANTENNA ROD
HINT:
Perform this operation with negative (−) cable connected to the
battery terminal.
(a) Turn the ignition switch to "LOCK" position.
(b) Remove the antenna nut.
(c) Press the "AM" buttons on the radio receiver, and simulta-
neously turn the ignition switch to "ACC" position.
HINT:
The rod will extend fully and be released from the motor
S
antenna.
After removing the antenna rod, leave the ignition switch
S
as "ACC".
NOTICE:
To prevent body damage when the antenna rod is released,
hold the rod while it comes out.
2. INSTALL ANTENNA ROD
(a) Insert the cable of the rod until it reaches the bottom.
HINT:
When inserting the cable, the teeth on the cable must face to-
ward the front of the vehicle.
(b) Wind the cable to retract the rod by turning the ignition
switch to "LOCK" position.
HINT:
If the ignition switch is already in "LOCK" position, perform
S
step 1 (c) first, then turn the ignition switch to "ACC" posi-
tion.
In case the cable is not wound, twist it as shown in the il-
S
lustration.
Even if the rod has not retracted fully, install the antenna
S
nut and inspect the antenna rod operation. It will finally re-
tract fully.
(c) Inspect the antenna rod operation by pushing the radio
wave band select buttons.
BE1PL−02