Torque Converter Clutch And Drive Plate Inspection - Toyota 2002 Camry Service Manual

40–20
AUTOMATIC TRANSMISSION / TRANS
TORQUE CONVERTER CLUTCH AND DRIVE PLATE
INSPECTION
Hold
Sample showing minimum amount of
powders in ATF
Actual Size
2002 CAMRY REPAIR MANUAL (RM881U)
SST
AT0953
Lock
Free
Turn
AT3306
D25367
– TORQUE CONVERTER CLUTCH AND DRIVE PLATE
1. INSPECT TORQUE CONVERTER CLUTCH ASSY
(a) Inspect the one–way clutch.
(1) Set SST into the inner race of the one–way clutch.
SST 09350–32014 (09351–32010)
(2) Install SST so that it fits in the notch of the converter
hub and outer race of the one–way clutch.
SST 09350–32014 (09351–32020)
(3) With the torque converter clutch setting up on its
side, check that the one–way clutch locks when it is
turned counterclockwise, and rotates clockwise
smoothly.
If necessary, clean the converter and retest the one–way
clutch.
Replace the converter if the one–way clutch still fails the test.
(b) Determine the condition of the torque converter clutch
assy.
(1) If the inspection result of the torque converter clutch
assy meets the following item, replace the torque
converter clutch.
Malfunction item:
Any metallic sound is heard from the torque convert-
er clutch during stall test or when the shift lever is in
neutral position.
One–way clutch is free or locked in both directions.
Fine powders exceeding the sample limit is identified
in ATF. (See the sample.)
HINT:
The sample shows the auto fluid of approx. 0.25 liters (0.26 US
qts, 0.22 Imp. qts) that is taken out from the removed torque
converter clutch
(c) Exchange the ATF in the torque converter clutch.
(1) If the ATF is discolored and/or has a foul odor, com-
pletely stir the ATF in the torque converter clutch
and drain the ATF with the torque converter facing
to up.
Author :
40063–02
Date :
2095