Ospf Area; Ospf Db; Ospf Neighbor; Ddrp Area - Alcatel-Lucent 1850 TSS-320 User Provisioning Manual

Procedures
............................................................................................................................................................................................................................................................
Parameter
Auto Config
Port ALM Enabled
Route ALM Enabled
Signal ALM Enabled
Advertise
Save
Control Plane Garbage Collection and Release CP Resources are useful to free all
unused CP transport resources.
On the Control plane page the following functional tabs are present as shown in
Figure

OSPF AREA

•

OSPF DB

•

OSPF NEIGHBOR

•

DDRP AREA

•

DDRP DB

•

DDRP NEIGHBOR

•
Configure OSPF AREA
Use this procedure to configure the OSPF Area.
........................................................................................................................................................................................................................
1 Clicking on the OSPF AREA functional tab, the following page appears.
............................................................................................................................................................................................................................................................
5 - 22
5-14:
Description
Allows to enable or disable the CP Auto Configuration mode.
The available choices are: ON (auto configuration enabled) or
OFF (auto configuration disabled).
Allows enabling or disabling the sending of event
notifications about port event to Control Plane system. The
available choices are: Y (alarm enabled) or N (alarm
disabled).
Allows enabling or disabling the sending of event
notifications about routing protection event for Control Plane
system. The available choices are: Y (alarm enabled) or N
(alarm disabled).
Allows enabling or disabling the sending of event
notifications about signaling event to Control Plane system.
The available choices are: Y (alarm enabled) or N (alarm
disabled).
The options are Y or N.
Allows to save the settings.
Control Plane - Configure OSPF and DDRP
Issue 3 July 2009
8DG08136EAAA