Dell PowerEdge M420 Reference Manual page 121

IP Routing
Command
encapsulation
ip address
ip mtu
ip netdirbcast
ip route
ip route default
ip route distance
ip routing
routing
show ip brief
show ip interface
show ip protocols
show ip route
show ip route preferences
show ip route summary
show ip traffic
show ip vlan
a. For the meaning of each Mode abbreviation, see Mode Types on page 77.
Description
Configures the link layer encapsulation type for
the packet.
Configures an IP address on an interface.
Sets the IP Maximum Transmission Unit
(MTU) on a routing interface.
nables the forwarding of network-directed
E
broadcasts.
Configures a static route. Use the no form of
the command to delete the static route.
Configures the default route. Use the no form
of the command to delete the default route.
Sets the default distance (preference) for static
routes.
Globally enables IPv4 routing on the router.
Enables IPv4 and IPv6 routing for an interface. IC
Displays all the summary information of the IP. PE
Displays all pertinent information about the IP
interface.
Displays the parameters and current state of the
active routing protocols.
Displays the routing table.
Displays detailed information about the route
preferences.
Shows the number of all routes, including best
and non-best routes.
Displays IP statistical information.
Displays the VLAN routing information for all
VLANs with routing enabled.
Command Groups
a
Mode
IC
IC
IC
IC
GC
GC
GC
GC
PE
PE
PE
PE
PE
UE or
PE
PE
121