Table of Contents
Advertisement
Steps
1. Align the slot on the rear drive cage with the guide on the system.
2. Slide the rear drive cage towards the rear of the chassis.
3. Using a Phillips #2 screwdriver, tighten the blue thumbscrew that secures the rear drive cage to the system.
Figure 94. Installing the 2.5-inch rear drive cage
Next steps
1. Connect all the cables to the rear drive cage.
2.
Install the
drives.
3. If removed,
install the air
4. Follow the procedure listed in
Optional serial COM port
This is a service technician replaceable part only.
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1.
Lift the expansion card riser
connector on the system board.
2. Open the latch, slide the serial COM port out of the expansion card riser, and the lock the latch .
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
shroud.
After working inside your
Safety
instructions.
Before working inside your
(Riser 1, Riser 2a, Riser 2b, Riser 2c) and disconnect the serial COM port cable from the
system.
system.
Installing and removing system components
95
Advertisement
Table of Contents
