Dell PowerEdge M420 Reference Manual page 110

Command
protocol vlan group all
show dvlan-tunnel
show dvlan-tunnel interface Displays detailed information about Double
show interfaces switchport Displays switchport configuration.
show port protocol
show vlan
show vlan association mac
show vlan association
subnet
switchport access vlan
switchport forbidden vlan
switchport general
acceptable-frame-type
tagged-only
switchport general allowed
vlan
switchport general ingress-
filtering disable
switchport general pvid
switchport mode
switchport trunk
110
Command Groups
Description
Adds all physical unit/slot/port interfaces to the
protocol-based VLAN identified by
Displays all interfaces enabled for Double
VLAN Tunneling.
VLAN Tunneling for the specified interface.
Displays the Protocol-Based VLAN information
for either the entire system or for the indicated
group.
Displays detailed information, including
interface information and dynamic vlan type,
for a specific VLAN.
Displays the VLAN associated with a specific
configured MAC address.
Displays the VLAN associated with a specific
configured IP subnet.
Configures the VLAN ID when the interface is
in access mode.
Forbids adding specific VLANs to a port.
Discards untagged frames at ingress.
Adds or removes VLANs from a port in General
mode.
Disables port ingress filtering.
Configures the PVID when the interface is in
general mode.
Configures the VLAN membership mode of a
port.
Adds or removes VLANs from a trunk port.
Mode
GC
groupid
.
PE
PE
PE
PE
PE
PE
PE
IC
IC
IC
IC
IC
IC
IC
IC
a