Interface Naming For A Routing Matrix Based On A Tx Matrix Router; Interface Naming For A Routing Matrix Based On A Tx Matrix Plus; Router; Chassis Interface Naming - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Physical Part of an Interface Name
The physical part of an interface name identifies the physical device, which
corresponds to a single physical network connector. This part of the interface name
has the following format:
type
the following:
Interface Naming for a Routing Matrix Based on a TX Matrix Router on page 58

Interface Naming for a Routing Matrix Based on a TX Matrix Plus

Router on page 60
Chassis Interface Naming on page 62
Examples: Interface Naming on page 63
type-fpc/pic/port
is the media type, which identifies the network device where it can be one of
ae —Aggregated Ethernet interface. This is a virtual aggregated link and has a
different naming format from most PICs; for more information, see "Aggregated
Ethernet Interfaces Overview" on page 643.
—Aggregated SONET/SDH interface. This is a virtual aggregated link and has
as
a different naming format from most PICs; for more information, see "Configuring
Aggregated SONET/SDH Interfaces" on page 936.
at —ATM1 or ATM2 intelligent queuing (IQ) interface or a virtual ATM interface
on a Circuit Emulation (CE) interface.
—Gigabit Ethernet internal interface
bcm
br —Integrated Services Digital Network (ISDN) interface (configured on a 1-port
or 4-port Basic Rate Interface (BRI) card). This interface has a different naming
format from most PICs:
information, see "Configuring ISDN Physical Interface Properties" on page 873.
—Channelized AU-4 IQ interface (configured on the Channelized STM1 IQ
cau4
or IQE PIC or Channelized OC12 IQ and IQE PICs).
ce1 —Channelized E1 IQ interface (configured on the Channelized E1 IQ PIC or
Channelized STM1 IQ or IQE PIC).
—Container interface.
ci
coc1 —Channelized OC1 IQ interface (configured on the Channelized OC12 IQ
and IQE or Channelized OC3 IQ and IQE PICs).
—Channelized OC3 IQ interface (configured on the Channelized OC3 IQ
coc3
and IQE PICs).
coc12 —Channelized OC12 IQ interface (configured on the Channelized OC12
IQ and IQE PICs).
coc48 —Channelized OC48 interface (configured on the Channelized OC48 and
Channelized OC48 IQE PICs).
—Collector interface (configured on the Monitoring Services II PIC).
cp
Chapter 2: Understanding Router Interfaces
. The second number is always 0. For more
br-pim/0/port
Interface Naming Overview
53