Maintenance Procedures; Air Filter - BRP can-am OUTLANDER 2021 Series Operator's Manual

MAINTENANCE PROCEDURES

This section includes instructions for
basic maintenance procedures.
WARNING
Unless otherwise indicated, al-
ways remove D.E.S.S. key from
D.E.S.S. post before performing
any maintenance.
WARNING
Should removal of a locking de-
vice be required (e.g. lock tab,
self-locking fastener, etc.), always
replace it with a new one.

Air Filter

Air Filter Maintenance Guideline
As with any ATV, air filter maintenance
is critical to ensure proper engine per-
formance and life span.
Air filter maintenance should be ad-
justed according to riding conditions.
Air filter maintenance must be in-
creased in frequency and oil must be
added to the foam filter for the follow-
ing dusty conditions:
– Riding on dry sand.
– Riding on dry dirt covered surfaces.
– Riding on dry gravel trails or similar
conditions.
NOTE: Riding in a group in these con-
ditions would increase even more the
air filter maintenance. Refer to
FILTER CLEANING AND OILING
section for maintenance procedure.
NOTE: An accessory pre-filter for
"dusty conditions" may be used. Con-
tact an authorized Can-Am de aler for
details.
______________
144
Air Filter Removal
NOTICE
ify any component in the air filter
housing. Otherwise, engine perfor-
mance degradation or damage can
occur. The engine is calibrated to
operate specifically with these com-
ponents.
Remove seat.
Remove console.
Lift rear portion of console upwards
until the studs are released from the
grommets.
vmo2014-007-001_a
TYPICAL
1. Console
2. Studs and grommets
Pull console rearwards.
Rotate air filter cover counterclock-
AIR
wise to remove.
in this
NOTE: A socket wrench may be used
to ease removal.
Never remove or mod-