Special Procedures; Atv Immersion - BRP BOMBARDIER DS250 2006 Shop Manual

SPECIAL PROCEDURES

SERVICE PRODUCTS
Description
XP-S Lube ............................................................................. 293 600 016 ........................................... 11

ATV IMMERSION

ATV Submerged for a Long Time
(over one hour)
Disassemble engine and transmission to clean the
internal parts and check if there is no rust or corro-
sion on any internal parts. Refer to ENGINE sec-
tion.
Drain air filter box then clean and dry air filter.
Remove muffler and empty it. Let muffler dry
then reinstall it on the vehicle.
Flush fuel tank and refill with new gas.
Clean and lubricate carburetor. Refer to CARBU-
RETOR.
Look for water in brake system. Replace brake
fluid if necessary.
Lubricate all cables. Check if the cables operate
properly.
Spray all metal parts with XP-S Lube (P/N 293 600
016).
Test drive to confirm all is working well (electrical
and mechanical components).
ATV Submerged for a Short Time
(fewer one hour)
Check if engine oil is contaminated (oil will be
milky). If so, perform the following instructions.
– Drain engine oil.
– Drain air filter housing then clean and dry air
filter.
– Look for water in fuel tank, in doubt, flush fuel
tank and refill with new gas.
– Remove the drain tube underneath CVT cover
to drain water. Remove the CVT cover then
clean and check all parts of CVT. Refer to CVT.
vmr2006-064
Section 01 MAINTENANCE
Subsection 04 (SPECIAL PROCEDURES)
Part Number
vmr2006-064-001_a
1. CVT cover drain tube
2. CVT cover
3. LH footrest
– Lubricate all cables. Check if the cables operate
properly.
– Remove spark plug then crank engine slowly
several times.
– Add a small quantity of engine oil in cylinder
(approximately 2 teaspoonfuls). Do not reinstall
spark plug at this moment.
– Refill engine at the proper level with the recom-
mended oil. Crank engine several times.
– Check condition of spark plug. If spark plug ap-
pears good reinstall it, if not install a new one.
– Start the engine and allow it to run at idle speed
until the engine reaches its operating tempera-
ture.
– Stop the engine.
– Change engine oil and clean oil strainer.
NOTE: Change oil as many times as necessary,
until there is no white appearance in engine oil.
Spray all metal parts with XP-S Lube (P/N 293 600
016).
Test drive to confirm all is working well (electrical
and mechanical components).
Page
11