Section 07 STEERING AND FRONT SUSPENSION
Subsection 01 (STEERING AND FRONT SUSPENSION)
vmr2006-083-009
Unscrew throttle clamp to separate throttle lever
from handlebar.
TYPICAL
1. Throttle clamp screws
Installation
For installation, reverse the removal procedure.
Make sure gasket inside cover is installed proper-
ly.
vmr2006-083-010_a
1. Gasket
2. Throttle housing cover
Refer to CARBURETOR AND FUEL TANK for
throttle cable adjustment procedure.
184
MASTER CYLINDER
Refer to BRAKING SYSTEM.
HANDLEBAR
Removal
Procedure if Handlebar is not Replaced
All Models except Europe
Remove steering cover by unscrewing both retain-
ing screws.
vmr2006-083-011_a
Remove handlebar bolts, steering cover support
and steering clamps.
vmr2006-083-013_a
1. Handlebar bolt
2. Steering clamps
3. Steering cover support
Move handlebar toward the front of vehicle.
European Models
On each side, remove screws retaining steering
cover to steering cover support.
vmr2006-083