Table of Contents
Advertisement
Subsection XX (STEERING SYSTEM)
1
V07I0HA
1. Inner housing protector
7. Slide cable in clip slot and remove the end of
the cable from clip.
V07I0IA
8. Remove throttle cable from housing.
Throttle Lever Installation
For installation, reverse the removal procedure.
Adjust throttle cable. Refer to
ADJUSTMENT
.
BRAKE LEVER
Brake Lever Removal (From Vehicle)
1. Carry out steps in
BRAKE LEVER REMOVAL
(FROM HANDLEBAR)
NOTICE
Avoid spilling brake fluid on plastic,
rubber or painted parts.
10
THROTTLE CABLE
.
2. Disconnect brake hose, refer to
section.
Brake Lever Removal (At Handlebar)
1. Remove brake lever retaining screws.
vmr2008-068-004_a
TYPICAL
1. Remove these retaining screws
2. Separate brake lever from handlebar.
Brake Lever Installation
For installation, reverse the removal procedure
however, pay attention to the following.
TIGHTENING TORQUE
Brake lever mounting
screw
WARNING
If brake hose was disconnected, bleed brake
system. Refer to
BRAKES
STEERING COLUMN BEARING
The steering column bearing(s) used on these ve-
hicles are half bushings.
For inspection and replacement of steering col-
umn half bushings, refer to
in this subsection.
STEERING COLUMN
Steering Column Removal (Without a
DPS)
1. Remove gauge support, refer to
GAUGE AND ACCESSORIES
2. Remove the front body module, refer to
subsection.
Outlander Models
3. Remove dash board support.
BRAKES
sub-
9 N•m ± 1 N•m
(80 lbf•in ± 9 lbf•in)
subsection.
STEERING COLUMN
LIGHTS,
subsection.
BODY
vmr2013-039
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
