Pitman Arm (With A Dps) - BRP Can-Am Outlander 2015 Series Manual

1
V07I0SA
TYPICAL
1. Circlip
tmr2011-034-015_a
TYPICAL
1. Seal
2. Circlip
4. Install knuckle on a press.
5. Remove bearing from knuckle using an appro-
priate bearing remover.
tmr2011-034-109
NOTE: It may be necessary to heat the knuckle to
remove bearing.
vmr2013-039
Subsection XX (STEERING SYSTEM)
WARNING
Clean all grease from outside and inside of
knuckle before heating it.
Wheel Bearing Installation
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
To ease wheel bearing installation:
– Place bearing in a freezer for 10 minutes.
– Place knuckle in oven to 100°C (212°F) for
30 minutes maximum.
When knuckle is cooled down, install NEW circlip
and NEW seal.
PITMAN ARM (WITHOUT A DPS)
The pitman arm is replaced with the steering col-
umn. Refer to STEERING COLUMN
section.

PITMAN ARM (WITH A DPS)

DYNAMIC POWER STEERING (DPS)
Refer to
subsection.
in this sub-
15