Switching Between Master And Slave Modes; Cache Control Register - Hitachi SH7095 Hardware User Manual

3.3

Switching between Master and Slave Modes

The MD5 pin, one of the pins used to set the operating mode, is used to switch between master
and slave modes. See section 7, Bus State Controller, for more information about the master and
slave modes.
Table 3.4 Switching between the Master and Slave Modes
Pin
Level applied
3.4

Cache Control Register

See section 8, Cache.
MD5
1
0
Operating Mode
Slave mode
Master mode
Hitachi 51