Chapter 13 Add And Remove Nodes; Before You Begin; Ntp-H97 Add A Path Protection Node - Cisco ONS 15310-MA SDH Procedure Manual

Add and Remove Nodes
This chapter explains how to add and remove Cisco ONS 15310-MA SDH nodes from path protection
configurations and linear add-drop multiplexers.

Before You Begin

Before performing any of the following procedures, complete the
Provisioning" procedure on page
to the Cisco ONS 15310-MA SDH Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.

NTP-H97 Add a Path Protection Node

Purpose
Tools/Equipment
Prerequisite Procedures Cards must be installed and node turn-up procedures completed on the
Required/As Needed
Onsite/Remote
Security Level
According to local site practice, complete the
Step 1
page 14-2
78-19416-01
NTP-H97 Add a Path Protection Node, page
NTP-H98 Remove a Path Protection Node, page
NTP-H99 Add an End Node to a Linear ADM, page
NTP-H135 Add a Non-ONS 15310-MA Node to a Linear ADM, page
add an ONS 15600, ONS 15454, or ONS 15310-MA SDH node to a linear configuration where an
ONS 15310-MA SDH is an end node.
NTP-H101 Remove an In-Service Node from a Linear ADM, page
remove an node from a linear ADM without disrupting traffic.
This procedure adds a node to a path protection configuration.
None
node that will be added to the path protection configuration. See
","
As needed
Onsite
Superuser only
for all the nodes in the ring.
C H A P T E R
8-2. Also investigate all alarms and clear any trouble conditions. Refer
13-1—Complete as needed.
13-4—Complete as needed.
13-6—Complete as needed.
and Chapter 3, "Turn Up a Node."
"NTP-H102 Back Up the Database" procedure on
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
13
"NTP-H56 Document Existing
13-7—Complete as needed to
13-9—Complete as needed to
Chapter 1,
13-1