Cisco ONS 15310-MA SDH Procedure Manual page 251

Chapter 12 Convert Network Configurations
Complete the
Step 1
ADM.
Complete the
Step 2
Complete the
Step 3
recreated after the 1+1 protection groups are deleted.
Complete the
Step 4
that supports the point-to-point or linear ADM span.
Complete the
Step 5
recreate the circuits one at a time.
Step 6 Complete the
in all nodes that will be part of the path protection configuration. Alternatively, if additional bandwidth
is needed for CTC management, complete the
page 16-71.
Note
Note
Stop. You have completed this procedure.
78-19416-01
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H163 Check the Network for Alarms and Conditions" task on page
"DLP-H115 Delete Circuits" task on page 17-19
"DLP-H138 Delete a Protection Group" task on page 17-41
"NTP-H47 Create an Automatically Routed Optical Circuit" procedure on page 5-32
"DLP-H52 Provision Section DCC Terminations" task on page 16-68
If you want to add additional nodes to the path protection configuration, see the
a Path Protection Node" procedure on page
Path protection is the default configuration if the cards are installed and the DCCs are
configured.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
at a node on the point-to-point or linear
for each circuit. The circuits will be
"DLP-H53 Provision Line DCC Terminations" task on
13-1.
Before You Begin
17-56.
for each 1+1 protection group
at the protect ports
"NTP-H97 Add
12-7
to