Ntp-H148 Verify Card And Sfp Installation; Chapter 3 Turn Up A Node - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
11.
12.

NTP-H148 Verify Card and SFP Installation

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
According to your site plan, verify that the 15310E-CTX-K9s are installed.
Step 1
Step 2 Verify that the green ACT (active) LED is illuminated on one 15310E-CTX-K9 and the amber STBY
(standby) LED is illuminated on the second 15310E-CTX-K9, if present.
Note
If you installed an electrical card, verify that it displays a solid green ACT (active) LED on the card
Step 3
faceplate. As necessary, complete the
If you installed an electrical card, verify that the electrical cables are installed. As necessary, complete
Step 4
the
Step 5 If you installed an Ethernet card, verify that it displays a solid green ACT (active) LED. To perform
Ethernet card installation, complete the
Step 6 To install a small-form factor pluggable (SFP) connector for the ONS 15310-MA SDH, complete the
"DLP-H16 Install SFP Connectors" task on page
Remove SFP Connectors" task on page
Verify that fiber-optic cables are installed and connected to the locations indicated in the site plan. If the
Step 7
fiber-optic cables are not installed, complete the
page 1-29
Verify that fiber is routed correctly in the shelf assembly.
Step 8
Continue with the
Step 9
page
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
3-2
NTP-H131 Provision OSI, page
connected to network elements (NEs) that are based on the Open System Interconnection (OSI)
protocol stack. This procedure provisions the TID Address Resolution Protocol (TARP), OSI
routers, manual area addresses, subnetwork points of attachment, and IP-over-OSI tunnels.
NTP-H180 Provision Node for SNMPv3, page
management protocol (SNMP) will be used for network monitoring
This procedure verifies that the ONS 15310-MA SDH node is ready for
turn up.
An engineering work order, site plan, or other document specifying the
ONS 15310-MA SDH card installation
Chapter 1, "Install the Cisco ONS 15310-MA SDH"
As needed
Onsite
Provisioning or higher
If the 15310E-CTX-K9 cards are not installed, or if their LEDs are not illuminated as described,
do not proceed. Repeat the
page 1-16, or refer to the Cisco ONS 15310-MA SDH Troubleshooting Guide to resolve
installation problems before proceeding to the next step.
"NTP-H158 Install the Electrical Cables" procedure on page
for the ONS 15310-MA SDH.
"NTP-H20 Set Up Name, Date, Time, and Contact Information" procedure on
3-3.
3-13—Complete this procedure if the ONS 15310-MA SDH will be
3-14—Complete this procedure if simple network
"NTP-H153 Install the 15310E-CTX-K9 Cards" procedure on
"NTP-H155 Install the Electrical Cards" procedure on page
"NTP-H154 Install the Ethernet Cards" procedure on page
16-19. To remove an SFP, complete the
16-21.
"NTP-H160 Install Optical Cables" procedure on
Chapter 3 Turn Up a Node
1-27.
"DLP-H17
1-23.
1-19.
78-19416-01