Chapter 9 Change Port Settings; Before You Begin - Cisco ONS 15310-MA SDH Procedure Manual

Change Port Settings
This chapter explains how to change transmission settings on ports in a Cisco ONS 15310-MA SDH.

Before You Begin

Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15310-MA SDH Troubleshooting Guide as necessary.
Changing card or port settings can be service affecting. You should make all changes during a scheduled
Caution
maintenance window.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
78-19416-01
NTP-H86 Modify Line Settings and PM Parameter Thresholds for Electrical Ports,
page 9-2—Complete as needed.
NTP-H87 Modify Line Settings and PM Parameter Thresholds for Optical Ports,
page 9-2—Complete as needed.
NTP-H130 Manage Pluggable Port Modules, page
change, or delete pluggable port modules (PPMs), which provide STM1 or STM4 line rates for ONS
15310-MA SDH optical ports.
NTP-H92 Change Card or PPM Service State, page
NTP-H172 Provision the Soak Timer for an ML-100T-8 Card, page
C H A P T E R
9-3—Complete this procedure to provision,
9-4—Complete as needed.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
9
9-4—Complete as needed.
9-1