Cisco ONS 15310-MA SDH Procedure Manual page 182

Before You Begin
Click Next. If you chose Fully Protected, click OK in the confirmation dialog box to continue. If not,
Step 14
continue with
Step 15 If you selected Using Required Nodes/Spans in
continue with
a. In the Circuit Route Constraints area, choose the member that you want to route from the Route
Member number drop-down list.
Click a node or span on the circuit map.
b.
Click Include to include the node or span in the circuit, or click Exclude to exclude the node or span
c.
from the circuit. The order in which you choose included nodes and spans is the order in which the
circuit is routed. Click spans twice to change the circuit direction.
Repeat Steps
d.
Review the circuit route. To change the circuit routing order, choose a node in the Required
e.
Nodes/Lines or Excluded Nodes Links lists, then click the Up or Down buttons to change the circuit
routing order. Click Remove to remove a node or span.
Repeat Steps
f.
If you selected Review Route Before Creation in
Step 16
continue with
In the Route Review/Edit area, choose the member that you want to route from the Route Member
a.
number drop-down list.
Click a node or span on the circuit map.
b.
Review the circuit route. To add or delete a circuit span, choose a node on the circuit route. Blue
c.
arrows show the circuit route. Green arrows indicate spans that you can add. Click a span arrowhead,
then click Include to include the span or Remove to remove the span.
d. If the provisioned circuit does not reflect the routing and configuration you want, click Back to
verify and change the circuit information. If the circuit needs to be routed to a different path, see the
"NTP-H52 Create a Manually Routed VCAT Circuit" procedure on page 5-47
route yourself.
Repeat Steps
e.
Click Finish. The Circuits window appears.
Step 17
Note
In the Circuits window, verify that the circuits you created appear in the circuits list.
Step 18
As needed, complete the
Step 19
page 17-85
page 17-87.
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
5-46
Step 15.
Step 16:
b and c for each node or span you want to include or exclude.
a through e for each member.
Step 17:
a through d for each member.
Depending on the complexity of the network and number of members, the VCAT circuit creation
process might take several minutes.
"DLP-H190 Provision CE-100T-8 and CE-MR-6 Card Ethernet Ports" task on
and/or the "DLP-H191 Provision CE-100T-8 and CE-MR-6 Card POS Ports" task on
Chapter 5 Create Circuits and VC Low-order Path Tunnels
Step 10, complete the following substeps. If not,
Step 10, complete the following substeps; otherwise,
to assign the circuit
78-19416-01