Dlp-H82 Apply Alarm Profiles To Cards And Nodes - Cisco ONS 15310-MA SDH Procedure Manual

c.
To apply profiles to all ports on a card:
Step 4
a.
b.
c.
d.
To reapply a previous alarm profile after you have applied a new one, select the previous profile and click
Step 5
Apply again.
Return to your originating procedure (NTP).
Step 6

DLP-H82 Apply Alarm Profiles to Cards and Nodes

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, click the Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
To apply profiles to a card:
Step 2
a.
b.
c.
Step 3 To apply the profile to an entire node:
a.
b.
c.
To reapply a previous alarm profile after you have applied a new one, select the previous profile and click
Step 4
Apply again.
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-100
Click Apply.
In card view, click the Force all ports to profile menu arrow at the bottom of the window.
Choose the new profile from the drop-down list.
Click Force (still need to "Apply").
Click Apply.
This task applies a custom or default alarm profile to cards or nodes.
None
DLP-H79 Create a Cloned Alarm Severity Profile, page 16-96
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Click the Profile row for the card.
Choose the new profile from the drop-down list.
Click Apply.
Click the Node Profile menu arrow at the bottom of the window.
Choose the new alarm profile from the drop-down list.
Click Apply.
Chapter 16 DLPs H1 to H99
78-19416-01