Dlp-H205 Provision Osi Routers; Dlp-H206 Provision Additional Manual Area Addresses - Cisco ONS 15310-MA SDH Procedure Manual

DLP-H205 Provision OSI Routers

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The Router 1 manual area address, System ID, and Selector "00" create the node NSAP address.
Note
Changing the Router 1 manual area address changes the node's NSAP address.
The System ID for Router 1 is the node MAC address.
Note
In node view, click the Provisioning > OSI > Routers > Setup tabs.
Step 1
Chose the router you want provision and click Edit.
Step 2
In the OSI Router Editor dialog box:
Step 3
a.
b.
c.
d.
Return to your originating procedure (NTP).
Step 4

DLP-H206 Provision Additional Manual Area Addresses

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-6
This task enables the OSI virtual router and edits its primary manual area
address.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Check Enable Router to enable the router and make its primary area address available for editing.
Click the manual area address, then click Edit.
In the Edit Manual Area Address dialog box, edit the primary area address in the Area Address field.
If you prefer, click Use Mask and enter the edits in the Masked NSAP Entry dialog box. The address
(hexadecimal format) can be 8 to 24 alphanumeric characters (0–9, a–f) in length.
Click OK successively to close the following dialog boxes: Masked NSAP Entry (if used), Edit
Manual Area Address, and OSI Router Editor.
This task provisions the OSI manual area addresses. Three additional
manual areas can be created for each virtual router.
None
DLP-H205 Provision OSI Routers, page 18-6
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Chapter 18 DLPs H200 to H299
78-19416-01