Dlp-H280 Path Protected Switching Test - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Table 18-22
Parameter
PSD-W
PSC-S
PSD-S
PSC-R
PSD-R
15 Min radio button
1 Day radio button
Return to your originating procedure (NTP).
Step 5

DLP-H280 Path Protected Switching Test

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Although a service interruption of less than 60 ms might occur, the test circuit should continue to work
Note
before, during, and after the switches. If the circuit stops working, do not continue. Contact your next
level of support.
78-19416-01
STM-N Threshold Options (continued)
Description
Protection Switching Duration—Working Line. Available for Line; Near
End and Far End.
MS-SPRing is not supported on the STM-1 card; therefore, the
Note
PSD-WPM parameter does not increment.
Protection Switching Count—Span. Available for Line; Near End and Far
End.
MS-SPRing is not supported on the STM-1 card; therefore, the
Note
PSC-S PM parameter does not increment.
Protection Switching Duration—Span. Available for Line; Near End and
Far End.
MS-SPRing is not supported on the STM-1 card; therefore, the
Note
PSD-S PM parameter does not increment.
Protection Switching Count—Ring. Available for Line; Near End and Far
End.
MS-SPRing is not supported on the STM-1 card; therefore, the
Note
PSC-R PM parameter does not increment.
Protection Switching Duration—Ring. Available for Line; Near End and
Far End.
Note MS-SPRing is not supported on the STM-1 card; therefore, the
PSD-R PM parameter does not increment.
Clicking this radio button and then clicking Refresh will cause the
threshold values on this tab to display for 15-minute intervals.
Clicking this radio button and then clicking Refresh will cause the
threshold values on this tab to display for 1-day intervals.
This task verifies that an SNCP span is switching correctly.
None
DLP-H29 Log into CTC, page 16-43
Required
Onsite or remote
Provisioning or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-79