Cisco ONS 15310-MA SDH Procedure Manual page 288

Note
In node view, click the Circuits tab and verify that no circuits appear, then proceed to
Step 4
appear, complete the
circuits that originate or terminate in the node. Repeat until no circuits appear.
Step 5 Complete the
any optical protection group. Repeat until no optical protection groups remain.
Complete the
Step 6
Delete a Line DCC Termination" task on page 17-55
terminations exist.
Complete the
Step 7
the Out-of-Service and Management,Disabled (locked-enabled,disabled) service state.
Remove all fiber connections to the cards.
Step 8
Complete the
Step 9
In node view, right-click an installed card and choose Delete Card.
Step 10
Click Yes.
Step 11
After you have deleted the cards, open the card ejectors for each card and remove each card from the
Step 12
node.
Shut off the power from the power supply that feeds the node.
Step 13
Disconnect the node from its external fuse source.
Step 14
Store all cards that was removed and update inventory records according to local site practice.
Step 15
Note
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
15-2
Current configurations will be saved if Steps
"NTP-H71 Modify and Delete Circuits" procedure on page 6-3
"NTP-H143 Modify or Delete Card Protection Settings" procedure on page 10-4
"DLP-H154 Delete a Section DCC Termination" task on page 17-54
"DLP-H50 Change the Service State for a Port" task on page 16-67
"DLP-H17 Remove SFP Connectors" task on page 16-21
In OSP installations, to power down the ONS 15310-MA SDH chassis without powering down
the OSP cabinet, remove the top two fuses in the Valere control module.
top two fuses in the Valere control module.
Chapter 15
4 through 11 are skipped.
for all ports. Repeat until no RS-DCC or MS-DCC
if there are any SFPs installed.
Power Down the Node
Step 5. If circuits
to delete all the
to delete
or the "DLP-H155
to change all ports to
Figure 15-1 shows the
78-19416-01