Cisco ONS 15310-MA SDH Procedure Manual page 136

Before You Begin
NTP-H35 Create a Logical Network Map
Purpose
Tools
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
already logged in, continue with Step 2.
From the View menu choose Go to Network View.
Step 2
Change the position of the nodes in the network view according to your plan.
Step 3
a.
b.
c.
On the network view map, right-click and choose Save Node Position.
Step 4
Click Yes in the Save Node Position dialog box.
Step 5
CTC displays a progress bar and saves the new node positions.
Note
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
4-22
This procedure positions nodes in the network view. This procedure allows
a superuser to create a consistent network view for all nodes on the
network.
None
NTP-H26 Verify Node Turn-Up, page 4-2
This procedure also assumes that network turn up is completed.
As needed
Onsite or remote
Superuser
"DLP-H29 Log into CTC" task on page 16-43
Press the Ctrl key while you drag and drop a node icon to a new location.
Deselect the previously selected node.
Repeat Steps a and b for each node you need to position.
Retrieve, Provisioning, and Maintenance users can move nodes on the network map, but only
Superusers can save new network map configurations. To restore the view to a previously saved
version of the network map, right-click the network view map and choose Reset Node Position.
Chapter 4 Turn Up a Network
at any node on the network. If you are
78-19416-01