Dlp-H136 Enable Dialog Box Do-Not-Display Option - Cisco ONS 15310-MA SDH Procedure Manual

Table 17-7
Domain action
Preview domain
contents
Remove domain
Return to your originating procedure (NTP).
Step 3

DLP-H136 Enable Dialog Box Do-Not-Display Option

Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
If any user who has rights to perform an operation (for example, creating a circuit) selects the "Do not
Note
show this dialog again" check box on a dialog box, the dialog box does not appear for any other users
who perform that operation on the network unless the command is overridden using the following task.
From the Edit menu, choose Preferences.
Step 1
Step 2 In the Preferences dialog box, click the General tab.
The Preferences Management area lists all dialog boxes where "Do not show this dialog again" was
checked.
Step 3 Choose one of the following:
•
•
Click OK.
Step 4
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
17-40
Managing Domains (continued)
Steps
Right-click the domain icon and choose Show Domain Overview. The domain
icon shows a small preview of the nodes in the domain. To turn off the domain
overview, right-click the overview and choose Show Domain Overview.
Right-click the domain icon and choose Remove Domain. Any nodes in the
domain are returned to the network map.
This task enables or disables the "Do not display" dialog box preference for
subsequent sessions.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Don't Show Any—Hides all do-not-display check boxes.
Show All—Overrides do-not-display check box selections and displays all dialog boxes.
Chapter 17 DLPs H100 to H199
78-19416-01