Dlp-H296 Repair Server Trails - Cisco ONS 15310-MA SDH Procedure Manual

Hide thumbs Also See for ONS 15310-MA SDH:
Table of Contents

Advertisement

In the Change Card dialog box, choose the new STM-N type.
Step 4
Click OK.
Step 5
When you have finished Steps
Step 6
and attach the fiber to the cards. Wait for the IMPROPRMVL alarm to clear and the cards to become
active.
Step 7
Return to your originating procedure (NTP).

DLP-H296 Repair Server Trails

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The Server Trail Repair wizard can only fix the IP address changes and cannot fix Server Trail
Note
terminations when you migrate from IPv4 to IPv6 addresses.
The Server Trail Repair wizard cannot repair the Server Trails when IP address of nodes on both ends of
Note
the Server Trail are changed.
When Server Trails are created on an IPv4 or IPv6 node and the IP address of the node changes, make
Note
sure that the Server Trail Repair wizard is launched on the IP address of the node that changed. For
example, if the IP address of Server Trails created on an IPv4 node changes, run the Server Trail Repair
wizard on the IPv4 node and not on the IPv6 node.
Step 1
Complete the
Trails. If you are already logged in, continue with
Note
From the View menu, choose Go to Network View.
Step 2
Choose the Tools > Links > Repair Server Trails option from the tool bar.
Step 3
The Server Trail Repair wizard appears.
Specify the changed IP address.
Step 4
The Server Trail Repair window provides the following options, as shown in
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-92
3
through
This procedure repairs Server Trail terminations in cases where IP address
changes for a node connected by a Server Trail link.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
The Server Trail Repair wizard works only when nodes at both ends of the Server Trail are added
in the CTC. If CTC is launched after the IP address is changed or if the node on any of the sides
is not discovered automatically, then the node has to be added manually into the CTC.
5
for both nodes, install the new STM-N cards in both endpoints
at the node where you will repair Server
Step
2.
Chapter 18
DLPs H200 to H299
Figure
18-6:
78-19416-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents