Ntp-H95 Convert A Point-To-Point Or Linear Adm To A Path Protection Manually - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin
If overhead circuits exist on the network, an in-service topology upgrade is service affecting. The
Note
overhead circuits will drop traffic and have a status of PARTIAL after the upgrade is complete.
Complete the
Step 1
ADM. If you are already logged in, continue with Step 2.
If the point-to-point or linear ADM is 1+1 protected, complete the
Step 2
Group" task on page
Step 3 Complete the
support the point-to-point or linear ADM span. (Alternatively, if additional bandwidth is needed for CTC
management, complete the
Provision the pluggable port module that is not already in the RS-DCC Terminations list.
From either network or node view, click the Circuits tab. Click the circuit you want to upgrade to select
Step 4
it.
From the Tools menu, choose Topology Upgrade > Convert Unprotected to Path Protection.
Step 5
To set the path protection parameters, complete the
Step 6
During Circuit Creation" task on page
Click Next.
Step 7
Complete one of the following tasks:
Step 8
a.
b.
Stop. You have completed this procedure.
NTP-H95 Convert a Point-to-Point or Linear ADM to a Path
Protection Manually
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This procedure is service affecting. All circuits are deleted and reprovisioned.
Caution
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
12-6
"DLP-H29 Log into CTC" task on page 16-43
17-41. If the point-to-point or linear ADM is unprotected, continue with
"DLP-H52 Provision Section DCC Terminations" task on page 16-68
"DLP-H53 Provision Line DCC Terminations" task on page
To route the new path protection circuit manually, complete
Protection Circuit in a Topology Upgrade" task on page
To route the new path protection circuit automatically, complete
a Path Protection Circuit in a Topology Upgrade" task on page
This procedure upgrades a point-to-point system to a path protection
manually, that is, without using the in-service topology upgrade wizard.
Use this procedure if the wizard is unavailable or you need to back out
of the wizard.
None
NTP-H27 Provision a Point-to-Point Network, page 4-3
NTP-H29 Provision a Linear ADM Network, page 4-6
As needed
Onsite or remote
Provisioning or higher
at a node on the point-to-point or linear
"DLP-H57 Provision Path Protection Selectors
16-75.
"DLP-H164 Manually Route a Path
17-57.
Chapter 12 Convert Network Configurations
"DLP-H138 Delete a Protection
at the nodes that
16-71.)
"DLP-H165 Automatically Route
17-57.
or
Step 4.
78-19416-01