Cisco ONS 15310-MA SDH Procedure Manual page 82

Required Tools and Equipment
If you are logged into CTC, on the node view shelf graphic right-click the card that you want to remove
Step 2
and choose Delete Card.
You cannot delete a card if any of the following conditions apply:
The card is a 15310E-CTX-K9 card. To replace a 15310E-CTX-K9 card, refer to the
•
Cisco ONS 15310-MA SDH Troubleshooting Guide.
• The card is part of an optical protection group; see the
on page
Note
The card has circuits; see the
•
"DLP-H115 Delete Circuits" task on page
The card is being used for timing; see the
•
page
The card has a data communications channel (DCC) termination; see the
•
Section DCC Termination" task on page 17-54
task on page
Note
Physically remove the card:
Step 3
Open the card latches/ejectors.
a.
Use the latches/ejectors to pull the card forward and away from the shelf.
b.
Insert the new card using one of the following procedures:
Step 4
NTP-H153 Install the 15310E-CTX-K9 Cards, page 1-16
•
NTP-H154 Install the Ethernet Cards, page 1-19
•
NTP-H155 Install the Electrical Cards, page 1-23
•
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
1-34
17-41.
1:1 electrical protection groups are created automatically in the ONS 15310-MA SDH and
can only be deleted after the protect card of a 1:1 protection group is deleted.
17-42.
17-55.
If you do not remove a card from the shelf after you delete it in CTC, it will reboot and reappear
in CTC when you add card back.
"DLP-H138 Delete a Protection Group" task
"DLP-H120 Delete Overhead Circuits" task on page 17-26
17-19.
"DLP-H139 Change the Node Timing Source" task on
or the "DLP-H155 Delete a Line DCC Termination"
Chapter 1 Install the Cisco ONS 15310-MA SDH
"DLP-H154 Delete a
and the
78-19416-01