Cisco ONS 15310-MA SDH Procedure Manual page 193

Chapter 5 Create Circuits and VC Low-order Path Tunnels
If you want to set preferences for individual members, complete the following in the Member
Step 12
Preferences area. To set identical preferences for all members, skip this step and continue with
• Number—Choose a number from the drop-down list to identify the member.
Name—Type a unique name to identify the member. The name can be alphanumeric and up to
•
48 characters (including spaces). If you leave the field blank, CTC assigns a default name to the
circuit.
Protection—Choose the member protection type:
•
–
–
–
–
• Node-Diverse Path—(Split routing only) Available for each member when Fully Protected is
chosen.
Step 13 To set preferences for all members, complete the following in the Set Preferences for All Members area:
• Protection—Choose the member protection type:
–
–
–
–
Node-Diverse Path—(Split routing only) Available when Fully Protected is chosen.
•
Click Next. If you chose Fully Protected, click OK to continue. If not, continue with the next step.
Step 14
In the Route Review and Edit area, node icons appear so you can route the circuit manually.
Step 15
Complete the
Step 16
Click Finish. If the path does not meet the specified path diversity requirement, CTC displays an error
Step 17
message and allows you to change the circuit path.
Note
When all the circuits are created, the main Circuits window appears. Verify that the circuits you created
Step 18
appear in the window.
Stop. You have completed this procedure.
78-19416-01
Fully Protected—Routes the circuit on a protected path.
Unprotected—Creates an unprotected circuit.
PCA—(Future use) Routes the member on a BLSR protection channel.
Although ONS 15310-CLs and ONS 15310-MAs do not support BLSR, you can route
Note
an LCAS VCAT circuit over a BLSR network of ONS 15600s or ONS 15454s.
DRI—(Split routing only) Routes the member on a DRI circuit.
Fully Protected—Routes the circuit on a protected path.
Unprotected—Creates an unprotected circuit.
PCA—(Future use) Routes the member on a BLSR protection channel.
DRI—(Split routing only) Routes the member on a DRI circuit.
"DLP-H66 Provision a VCAT Circuit Route" task on page
Depending on the complexity of the network and number of members, the CCAT/VCAT circuit
creation process might take several minutes.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
Step
16-83.
5-57
13.