Dlp-H97 Monitor Pm Counts For Selected Signal Types - Cisco ONS 15310-MA SDH Procedure Manual

DLP-H97 Monitor PM Counts for Selected Signal Types

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click a 15310E-CTX-K9, electrical, or Ethernet card. The card view appears.
Step 1
Note
Step 2 Click the Performance tab.
Step 3 Click the E1, DS3, E3, or Optical tabs.
Note
Step 4 Click the Port/Line drop-down list and highlight the desired port/line. (Options vary depending on the
port.)
Click the signal type drop-down list and highlight the desired signal. (Options vary depending on the
Step 5
port.)
Click Refresh. All PM counts recorded by the near-end or far-end node appear for the specified outgoing
Step 6
signal type on the selected card and port. For PM parameter definitions, refer to the "Performance
Monitoring" chapter in the Cisco ONS 15310-MA SDH Reference Manual.
View the Curr column to find PM counts for the current time interval.
Step 7
View the Prev-n columns to find PM counts for the previous time intervals.
Step 8
Return to your originating procedure (NTP).
Step 9
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-114
This task enables you to monitor near-end or far-end PM counts for
specific signals on a selected card and port.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
In an ONS 15310-MA SDH node, the 15310E-CTX-K9 card provides optical ports and the
E1_21_E3_DS3_3 and E1_63_E3_DS3_3 cards provide electrical ports. The ONS 15310-MA
SDH supports Ethernet cards.
Different port and signal-type drop-down lists appear depending on the port type and the circuit
type. The appropriate types (E1, DS3, VC low-order path, VC high-order path, STM-M section,
and STM-M line) appear based on the card.
Chapter 16 DLPs H1 to H99
78-19416-01