Ntp-H66 Monitor Optical Performance; Ntp-H67 Monitor Ethernet Performance - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin

NTP-H66 Monitor Optical Performance

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
already logged in, continue with
Complete the
Step 2
page 16-115
Complete the
Step 3
need to monitor large amounts of VC (virtual container) traffic through intermediate nodes.
Complete the
Step 4
Note
Stop. You have completed this procedure.

NTP-H67 Monitor Ethernet Performance

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
7-4
This procedure allows you to view near-end or far-end performance on
an optical card and port at specified time intervals to detect possible
performance problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and VC Low-order Path Tunnels."
Settings."
As needed
Onsite or remote
Retrieve or higher
"DLP-H29 Log into CTC" task on page 16-43
Step
"DLP-H98 Enable Pointer Justification Count Performance Monitoring" task on
if you need to monitor clock synchronization.
"DLP-H99 Enable Intermediate-Path Performance Monitoring" task on page 16-116
"DLP-H100 View Optical STM-M PM Parameters" task on page 17-1
To refresh, reset, or clear PM counts, see the
page 7-2.
This procedure allows you to view node transmit and receive
performance on an Ethernet card and port at specified time intervals to
detect possible performance problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and VC Low-order Path Tunnels."
Settings."
As needed
Onsite
Retrieve or higher
at the node you want to monitor. If you are
2.
"NTP-H64 Change the PM Display" procedure on
Chapter 7 Monitor Performance
Chapter 5, "Create Circuits
and Chapter 9, "Change Port
as needed.
Chapter 5, "Create Circuits
and Chapter 9, "Change Port
if you
78-19416-01