Dlp-H213 Edit An Ip-Over-Clns Tunnel - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Choose the subnet you want to edit, then click Edit.
Step 2
In the Edit <subnet type> Subnet <slot/port> dialog box, edit the following fields:
Step 3
•
•
•
Note
Step 4 Click OK.
Return to your originating procedure (NTP).
Step 5

DLP-H213 Edit an IP-Over-CLNS Tunnel

Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
Changing the IP or NSAP addresses or an IP-over-CLNS tunnel can cause loss of NE visibility or NE
Caution
isolation. Do not change network addresses until you verify the changes with your network
administrator.
Click the Provisioning > OSI > Tunnels tabs.
Step 1
Click Edit.
Step 2
In the Edit IP Over OSI Tunnel dialog box, complete the following fields:
Step 3
•
78-19416-01
ESH—The End System Hello PDU propagation frequency. An end system NE transmits ESHs to
inform other ESs and ISs about the NSAPs it serves. The default is 10 seconds. The range is 10 to
1000 seconds.
ISH—The Intermediate System Hello PDU propagation frequency. An intermediate system NE
sends ISHs to other ESs and ISs to inform them about the NETs it serves. The default is 10 seconds.
The range is 10 to 1000 seconds.
IIH—The Intermediate System to Intermediate System Hello PDU propagation frequency. The IS-IS
Hello PDUs establish and maintain adjacencies between ISs. The default is 3 seconds. The range is
1 to 600 seconds.
The IS-IS Cost and DIS Priority parameters are provisioned when you create or enable a subnet.
You cannot change the parameters after the subnet is created. To change the DIS Priority and
IS-IS Cost parameters, delete the subnet and create a new one.
This task edits the parameters of an IP-over-CLNS tunnel.
None
DLP-H208 Create an IP-Over-CLNS Tunnel, page 18-8
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
Tunnel Type—Edit the tunnel type:
Cisco—Creates the proprietary Cisco IP tunnel. Cisco IP tunnels add the CLNS header to the
–
IP packets.
GRE—Creates a Generic Routing Encapsulation tunnel. GRE tunnels add the CLNS header and
–
a GRE header to the IP packets.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-11