Dlp-H61 Provision A Ds-3 Or E3 Circuit Source And Destination - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
If you want to change the source VC high-order path, adjust the Source VC high-order path field;
Step 3
otherwise, continue with
Step 4 If you want to change the source VC low-order path, adjust the Source VC low-order path field;
otherwise, continue with
Step 5 Repeat Steps
all intermediary nodes.
Return to your originating procedure (NTP).
Step 6

DLP-H61 Provision a DS-3 or E3 Circuit Source and Destination

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
After you have selected the circuit properties in the Circuit Source page according to the specific circuit
Note
creation procedure, you are ready to provision the circuit source.
From the Node drop-down list, choose the node where the source will originate.
Step 1
From the Slot drop-down list, choose the slot where the circuit will originate.
Step 2
From the Port drop-down list, choose the source port as appropriate.
Step 3
If you are creating a VC low-order path circuit, choose the VC low-order path from the VC low-order
Step 4
path drop-down list.
If you need to create a secondary source, for example, a path protection bridge/selector circuit entry
Step 5
point in a multivendor path protection configuration, click Use Secondary Source and repeat Steps
through
Step
Click Next.
Step 6
From the Node drop-down list, choose the destination (termination) node.
Step 7
From the Slot drop-down list, choose the slot containing the destination card.
Step 8
Depending on the destination card, choose the destination port or VC high-order path from the
Step 9
drop-down lists that display based on the card selected in
valid options. CTC does not display ports, VC high-order paths, VC low-order paths, or DS1s/E1s if they
are already in use by other circuits. If you and a user working on the same network choose the same port,
VC high-order path, VC low-order path, port, or E1 simultaneously, one of you will receive a Path in
Use error and be unable to complete the circuit. The user with the incomplete circuit needs to choose
new destination parameters.
78-19416-01
Step 4.
Step 5.
2 through 4 until the circuit is provisioned from the source to the destination node through
This task provisions an electrical circuit source and destination for a DS-3
or E3 circuit.
None
DLP-H29 Log into CTC, page 16-43
The Circuit Creation wizard Circuit Source page must be open.
As needed
Onsite or remote
Provisioning or higher
4 to define the secondary source. If you do not need to create a secondary source, continue with
6.
Step
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
2. See Table 5-1 on page 5-2
1
for a list of
16-79