Dlp-H41 Set Up Or Change Open Shortest Path First Protocol - Cisco ONS 15310-MA SDH Procedure Manual

In node view, click the Provisioning > Network > Static Routing tabs.
Step 1
Click Create.
Step 2
In the Create Static Route dialog box, enter the following:
Step 3
•
•
•
•
Click OK. Verify that the static route appears in the Static Route window.
Step 4
Note
Return to your originating procedure (NTP).
Step 5

DLP-H41 Set Up or Change Open Shortest Path First Protocol

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From node view, click the Provisioning > Network > OSPF tabs.
Step 1
On the top left side of the OSPF pane, complete the following:
Step 2
•
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-56
Destination—Enter the IP address of the computer running CTC. To limit access to one computer,
enter the full IP address and a subnet mask of 255.255.255.255. To allow access to all computers on
the 192.168.1.0 subnet, enter 192.168.1.0 and a subnet mask of 255.255.255.0. You can enter a
destination of 0.0.0.0 to allow access to all CTC computers that connect to the router.
Mask—Enter a subnet mask. If the destination is a host route (that is, one CTC computer), enter a
32-bit subnet mask (255.255.255.255). If the destination is a subnet, adjust the subnet mask
accordingly, for example, 255.255.255.0. If the destination is 0.0.0.0, CTC automatically enters a
subnet mask of 0.0.0.0 to provide access to all CTC computers. You cannot change this value.
Next Hop—Enter the IP address of the router port or the node IP address if the CTC computer is
connected to the node directly.
Cost—Enter the number of hops between the ONS 15310-MA SDH and the computer.
Static route networking examples are provided in the "Management Network Connectivity"
chapter in the Cisco ONS 15310-MA SDH Reference Manual.
This task enables the Open Shortest Path First (OSPF) routing protocol on
the ONS 15310-MA SDH. Perform this task if you want to include the
ONS 15310 in OSPF-enabled networks.
None
DLP-H29 Log into CTC, page 16-43
You will need the OSPF Area ID, Hello and Dead intervals, and
authentication key (if OSPF authentication is enabled) provisioned on the
router that the ONS 15310 is connected to.
As needed
Onsite or remote
Provisioning or higher
DCC/GCC OSPF Area ID Table—In dotted decimal format, enter the number that identifies the
ONS 15310 nodes as a unique OSPF area ID. It can be any number between 000.000.000.000 and
255.255.255.255. The number must be unique to the LAN OSPF area.
Chapter 16 DLPs H1 to H99
78-19416-01