Cisco ONS 15310-MA SDH Procedure Manual page 545

Chapter 18 DLPs H200 to H299
Table 18-11
Parameter
SD BER
Provides
Synch
SyncMsgIn
Admin SSM
Send <FF>
DoNotUse
Send
DoNotUse
PJSTSMon #
automaticInSer
vice Soak
78-19416-01
Optical Port Line Settings (continued)
Description
Sets the signal degrade bit error
rate.
(Display only) If checked, the card
is provisioned as a NE timing
reference.
Enables synchronization status
messages (S1 byte), which allow
the node to choose the best timing
source.
Allows you to override the
synchronization traceability
unknown (STU) value (default
setting).
When checked, sends a special
DUS (0xff) message on the S1
byte.
When checked, sends a DUS
message on the S1 byte.
Sets the VC high-order path that
will be used for pointer
justification. If set to OFF
(available for the ONS 15310-MA
SDH), no VC high-order path is
monitored. Only one VC
high-order path can be monitored
on each STM-M port.
Automatic in-service soak.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Options
1E-5
•
1E-6
•
1E-7 (default)
•
1E-8
•
1E-9
•
• Yes (checked)
• No (unchecked)
Yes (checked, default)
•
No (unchecked)
•
PRS: Primary Reference Source (Stratum 1)
•
ST2: Stratum 2
•
TNC: Transit node clock
•
ST3E: Stratum 3E
•
ST3: Stratum 3
•
SMC: SDH minimum clock
•
• ST4: Stratum 4
Yes
•
No
•
• Yes (checked)
No (unchecked, default)
•
0 or OFF (no VC high-order path used)
•
1 – 12 (STM4)
•
1 – 48 (STM16)
•
Duration of valid input signal in hh.mm
•
after which the card is set in service by the
software
• 0 to 48 hours, 15-minute increments
18-45