Dlp-H94 Reset Current Pm Counts - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 16 DLPs H1 to H99
Click Refresh. All PM parameters recorded by the far-end node for the selected card on the outgoing
Step 5
signal appear. For PM parameter definitions refer to the "Performance Monitoring" chapter in the
Cisco ONS 15310-MA SDH Reference Manual.
View the Curr column to find PM counts for the current time interval.
Step 6
Step 7 View the Prev-n columns to find PM counts for the previous time intervals.
Step 8 Return to your originating procedure (NTP).

DLP-H94 Reset Current PM Counts

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click a 15310E-CTX-K9, electrical, or Ethernet card. The card view appears.
Note
Step 2 Click the Performance tab.
•
•
•
Step 3 Click Baseline.
The Baseline button clears the PM counts displayed in the current time interval, but does not clear the
PM counts on the card. When the current time interval expires or the window view changes, the total
number of PM counts on the card and in the window appear in the appropriate column. The baseline
values are discarded if you change views to a different window and then return to the Performance
Monitoring window.
View the current statistics columns to observe changes to PM counts for the current time interval.
Step 4
Return to your originating procedure (NTP).
Step 5
78-19416-01
In an ONS 15310-MA SDH node, the 15310E-CTX-K9 card provides optical ports and the
E1_21_E3_DS3_3 and E1_63_E3_DS3_3 cards provide electrical ports. The ONS 15310-MA
SDH supports Ethernet cards.
To reset current PM Counts for optical ports click the Optical tab.
To reset current PM Counts for electrical ports click the E1, DS3, or E3 tabs.
To reset current PM counts for ML-Series and CE-Series Ethernet cards click the Ether Ports >
Statistics tabs or POS Ports > Statistics tabs.
This task uses the Baseline button to clear the PM count displayed in the
current time interval, but it does not clear the cumulative PM count. This
task allows you to see how quickly PM counts rise.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Retrieve or higher
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
16-111