Cisco ONS 15310-MA SDH Procedure Manual page 176

Before You Begin
Note
If you selected Fully Protected Path in
Step 14
check the Dual Ring Interconnect check box.
If you are creating an VC high-order path circuit, skip this step and continue with
Step 15
creating a VC low-order path circuit, click Next and complete the
path and VC Low-order Path Grooming Nodes" task on page
Click Next. In the Route Review and Edit area, node icons appear for you to route the circuit manually.
Step 16
The green arrows pointing from the selected node to other network nodes indicate spans that are
available for routing the circuit.
Step 17 Complete the
Click Finish. After completing the circuit, the Circuits window appears.
Step 18
In the Circuits window, click the circuit that you want to route to multiple drops. The Delete, Edit, and
Step 19
Search buttons become active.
Click Edit. The Edit Circuit window appears with the General tab selected. All nodes in the DCC
Step 20
network appear on the network. Circuit source and destination information appears under the source and
destination nodes. To display a detailed view of the circuit, click Show Detailed Map. You can rearrange
the node icons by selecting the node with the left mouse button, pressing Ctrl and dragging the icon to
the new location.
In the Edit Circuit dialog box, click the Drops tab. A list of existing drops appears.
Step 21
Click Create.
Step 22
In the Define New Drop dialog box, define the new drop:
Step 23
Node—Choose the target node for the circuit drop.
a.
Slot—Choose the target card and slot.
b.
Port, VC high-order path—Choose the port and/or VC high-order path from the Port and VC
c.
high-order path drop-down lists. The choice in these menus depends on the card selected in Step b.
See
The routing preferences for the new drop will match those of the original circuit. If the original
d.
circuit was routed on a protected path, you can change the nodal diversity options: Nodal Diversity
Required, Nodal Diversity Desired, or Link Diversity Only. See
Click OK. The new drop appears in the Drops list.
e.
If you need to create additional drops on the circuit, repeat Steps
Step 24
Click Close. The Circuits window appears.
Step 25
Verify that the new drops appear in the Destination column for the circuit you edited. If they do not
Step 26
appear, repeat Steps
Complete the
Step 27
circuit.
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
5-40
For manually routed circuits, CTC checks your manually provisioned path against the path
diversity option you choose. If the path does not meet the path diversity requirement that is
specified, CTC displays an error message.
"DLP-H64 Provision an STM-M Circuit Route" task on page
Table 5-1 on page 5-2 for a list of options.
5 through 25
"NTP-H50 Test Optical Circuits" procedure on page
Chapter 5
Step 12 and the circuit will be routed on a path protection DRI,
making sure all options are provisioned correctly.
Create Circuits and VC Low-order Path Tunnels
Step 16. If you are
"DLP-H59 Provision VC high-order
16-77.
16-82.
Step 13 for options descriptions.
21 through 23.
5-41. Skip this step if you built a test
78-19416-01