Dlp-H290 Manually Configure The Snmpv3 Proxy Trap Forwarder Table - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
•
Step 3 In the SNMPv3 Proxy Forwarder Table area, click Auto Create.
In the Automatic Configuration of SNMPv3 Proxy Forwarder dialog box, enter the following
Step 4
information:
•
•
•
•
Note When you configure SNMPv3 Proxy Forwarder Table automatically, the default_group is used on the
ENE. The default_group does not have write access. To enable write access and allow SNMP sets, you
need to edit the default_group on ENE.
Click OK to save the settings.
Step 5
Return to your originating procedure (NTP).
Step 6

DLP-H290 Manually Configure the SNMPv3 Proxy Trap Forwarder Table

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In network view, click Provisioning > SNMPv3 tabs.
In the SNMPv3 Proxy Server area, complete the following:
Step 2
•
•
In the SNMPv3 Proxy Trap Forwarder Table area, click Manual Create.
Step 3
78-19416-01
Select the Enable IPv6 Target/Trap check box if the nodes and the NMS stations are on an IPv6
network.
Proxy Type—Select the type of proxies to be forwarded. The options are Read and Write.
Security Level—Select the security level for the incoming requests that are to be forwarded. The
options are:
– noAuthNoPriv—Uses a username match for authentication.
– AuthNoPriv—Provides authentication based on the HMAC-MD5 or HMAC-SHA algorithms.
– AuthPriv—Provides authentication based on the HMAC-MD5 or HMAC-SHA algorithms.
Provides DES 56-bit encryption based on the CBC-DES (DES-56) standard, in addition to
authentication.
Target Address List—Select the proxy destination.
Local User Name—Select the user name from the list of users.
This procedure creates an entry in the SNMPv3 Proxy Trap Forwarder
Table.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
Select the GNE to be used as the SNMPv3 proxy server from the drop-down list.
Select the Enable IPv6 Target/Trap check box if the nodes and the NMS stations are on an IPv6
network.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-87