Ntp-H135 Add A Non-Ons 15310-Ma Node To A Linear Adm - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 13 Add and Remove Nodes
Complete the
Step 5
STM-M port at the new node. Make sure to set the Port State in the Create RS-DCC Termination dialog
box to unlocked. (Do not create a DCC termination on the protect port.)
Note
Complete the
Step 6
to the new node. If you are already logged in, continue with
Complete the
Step 7
Install the STM-M port that will connect to the new node. See
Step 8
on page
Note
Connect the working port at the existing linear ADM node to the working port at the new node. See
Step 9
"DLP-H18 Install Fiber-Optic Cables in a 1+1 Configuration" task on page
Connect the protect port at the existing linear ADM node to the protect port at the new node.
Step 10
Complete
Step 11
ports that connect to the new node.
Complete the
Step 12
for the two STM-M ports that connect to the new node.
Complete the
Step 13
STM-M port that connects to the working port on the new node. Make sure to set the Port State in the
Create RS-DCC Termination dialog box to unlocked. (Do not create a DCC termination for the protect
port.)
From the View menu, choose Go to Network View. Verify that the newly created linear ADM
Step 14
configuration is correct. A green span line should appear between each linear node.
Complete the
Step 15
that no unexpected alarms or conditions are present.
Stop. You have completed this procedure.

NTP-H135 Add a Non-ONS 15310-MA Node to a Linear ADM

Purpose
Tools/Equipment
78-19416-01
"DLP-H52 Provision Section DCC Terminations" task on page 16-68
DCC failure alarms appear after you create DCC terminations in the linear ADM node until you
connect the fiber during Step
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H163 Check the Network for Alarms and Conditions" task on page
16-19. If the ports are already installed, continue with
If the new node is not an ONS 15310-MA SDH, refer to the corresponding user documentation
for installation procedures.
NTP-H142 Create Protection Groups for ONS 15310-MA SDH, page 3-10
"NTP-H142 Create Protection Groups for ONS 15310-MA SDH" procedure on page 3-10
"DLP-H52 Provision Section DCC Terminations" task on page 16-68
"DLP-H163 Check the Network for Alarms and Conditions" task on page 17-56
This procedure adds an ONS 15600, ONS 15454, or ONS 15310-MA
SDH between two nodes in a 1+1 configuration. The ONS 15310-MA
SDH has four optical ports and can be added as a middle node.
None
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
13.
at the linear ADM node that will connect
Step
"DLP-H16 Install SFP Connectors" task
Step
Before You Begin
for the working
7.
17-56.
9.
16-21.
for the two STM-M
for the working
to verify
13-7