Cisco ONS 15310-MA SDH Procedure Manual page 50

Hide thumbs Also See for ONS 15310-MA SDH:
Table of Contents

Advertisement

Before You Begin
NTP-H156 Install the Filler Cards, page
12.
card (blank faceplate) in the expansion slot. If no Ethernet or electrical card is installed in the
expansion slot, you must install a filler card.
NTP-H157 Install Wires to Alarm, Timing, Craft, LAN, and UDC Pin Connections,
13.
page
channel (UDC) connections.
NTP-H158 Install the Electrical Cables, page
14.
cables that will carry electrical traffic.
NTP-H159 Install and Remove SFPs, page
15.
Small Form-factor Pluggables (SFPs) that provide a fiber-optic interface to the 15310E-CTX-K9
card.
NTP-H160 Install Optical Cables, page
16.
that will carry optical traffic.
17.
NTP-H164 Perform the Shelf Installation Acceptance Test, page
determine if you have correctly completed all other procedures in the chapter.
18.
NTP-H161 Preprovision an SFP Slot, page
preprovision SFPs, which provide a fiber-optic interface to the ONS 15310-MA SDH and can be
provisioned for various line rates.
NTP-H162 Preprovision a Card Slot, page
19.
preprovision an empty card slot with a card that will be installed later.
NTP-H163 Remove and Replace a Card, page
20.
and replace an ONS 15310-MA SDH card.
NTP-H168 Install the Front Door, page
21.
front door.
NTP-H190 Install the Rear Cover, page
22.
cover.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
1-2
1-26—Complete this procedure to install cables for alarms, timing, LAN, craft, and user data
Chapter 1
1-25—As needed, complete this procedure to install a filler
1-27—Complete this procedure to connect and route
1-28—As needed, complete this procedure to install
1-29—Complete this procedure to connect and route cables
1-31—Complete this procedure to
1-32—As needed, complete this procedure to
1-33—As needed, complete this procedure to
1-33—As needed, complete this procedure to remove
1-35—As needed, complete this procedure to install the
1-37—As needed, complete this procedure to install the rear
Install the Cisco ONS 15310-MA SDH
78-19416-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents