Dlp-H276 Configuring Windows Vista To Support Ctc - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Double-click the SetupCtc-version.exe file. This creates a directory named SetupCtc-version (at the
Step 4
same location), which contains the LDCACHE.exe file and other CTC files.
Step 5 Double-click the LDCACHE.exe file to install or reinstall the new CTC JAR files into the CTC cache
directory on your PC.
Step 6 Return to your originating procedure (NTP).

DLP-H276 Configuring Windows Vista to Support CTC

Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the following steps to disable Internet Explorer 7 protected mode:
Step 1
Perform a full installation of Windows Vista operating system on your computer. If Windows Vista is
Note
installed through operating system upgrade, then CTC will not work. Refer to the manufacturer's user
guide for instructions on how to install Windows Vista.
Note This procedure is needed only if CTC is launched from the Internet Explorer browser. If you start CTC
by downloading the CTC Launcher application from the node, perform the
Launcher Application from a Release 9.1 and Release 9.2 Node" section on page
a.
b.
c.
d.
e.
Complete the following steps to Disable TCP Autotuning:
Step 2
a.
b.
c.
d.
e.
78-19416-01
This task describes the configurations that must be done in Windows Vista
operating system prior to launching CTC.
None
As needed
Onsite or remote
None
Open Internet Explorer,
Click Tools > Internet Options.
Click Security tab.
Select the zone that is appropriate. Available options are: Local Intranet, Internet, and Trusted
Sites.
Check the Disable Protect Mode check box.
From the Windows Start menu, click Search > Search for Files and Folders. The Search window
appears.
On the right side of the window in the Search box, type Command Prompt and press Enter.
Windows will search for the Command Prompt application and list it in the search results.
Right click cmd and select Run as administrator.
Enter the administrator user ID and password and click OK.
A Command prompt windows appears. At the command prompt enter the following text:
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
"DLP-H267 Install the CTC
18-66.
18-75