Cisco ONS 15310-MA SDH Procedure Manual page 134

Before You Begin
NTP-H147 Provision an Integrated Path Protection Dual-Ring
Interconnect on the ONS 15310-MA SDH
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Complete the following steps if you have not provisioned the path protection configurations that you will
Step 2
interconnect in a path protection DRI. If the path protection configurations are created, go to Step 3.
a.
b.
Step 3 Verify that the path protection DRI interconnect nodes have fiber connections to the other interconnect
nodes. An example is shown in
two rings.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
4-20
This procedure provisions path protection configurations in an integrated
DRI topology.
None
NTP-H26 Verify Node Turn-Up, page 4-2
As needed
Onsite
Superuser
"DLP-H29 Log into CTC" task on page
Complete the "NTP-H31 Provision Path Protection Nodes" procedure on page 4-9
path protection configurations.
Complete the "NTP-H32 Path Protection Acceptance Test" procedure on page 4-11
protection configurations.
16-43. If you are already logged in, continue with
Figure 4-5 on page 4-21. This example shows a path protection DRI with
Chapter 4 Turn Up a Network
to provision the
to test the path
78-19416-01