Dlp-H217 Manage The Tarp Data Cache - Cisco ONS 15310-MA SDH Procedure Manual

View the following RIB information for Router 1:
Step 2
•
•
•
•
If additional routers are enabled, you can view their RIBs by choosing the router number in the Router
Step 3
field and clicking Refresh.
Step 4 Return to your originating procedure (NTP).

DLP-H217 Manage the TARP Data Cache

Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
Step 1 In node view, click the Maintenance > OSI > TDC tabs.
View the following TARP data cache information:
Step 2
•
•
•
If you want to query the network for an NSAP that matches a TID, complete the following steps.
Step 3
Otherwise, continue with
Note
a.
b.
c.
d.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-14
Subnet Type—Indicates the OSI subnetwork point of attachment type used to access the destination
address. Subnet types include RS-DCC, MS-DCC, GCC, OSC, and LAN.
Location—Indicates the subnet interface. For DCC subnets, the slot and port are displayed. LAN
subnets are shown as LAN.
Destination Address—The destination IS NSAP.
MAC Address—For destination NEs that are accessed by LAN subnets, the NE's MAC address.
This task allows you to view and manage the TARP data cache (TDC). The
TDC facilitates TARP processing by storing a list of TID-to-NSAP
mappings.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite or remote
Provisioning or higher
TID—The target identifier of the originating NE. For ONS 15310-MA SDH, the TID is the name
entered in the Node Name/TID field on the Provisioning > General tab.
NSAP/NET—The NSAP or Network Element Title (NET) of the originating NE.
Type—Indicates how the TDC entry was created:
Dynamic—The entry was created through the TARP propagation process.
–
Static—The entry was manually created and is a static entry.
–
Step
The TID to NSAP function is not available if the TDC is not enabled on the Provisioning > OSI >
TARP tab.
Click the TID to NSAP button.
In the TID to NSAP dialog box, enter the TID that you want to map to an NSAP.
Click OK, then click OK in the information message.
On the TDC tab, click Refresh.
4.
Chapter 18 DLPs H200 to H299
78-19416-01