Ntp-H184 Manually Provision A Gne/Ene To Send Snmpv3 Traps From An Ene Using Snmpv3; Snmpv3 - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 3 Turn Up a Node
NTP-H184 Manually Provision a GNE/ENE to Send SNMPv3
Traps from an ENE using SNMPv3
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
SNMPv3. If you are already logged in, go to
Go to network view.
Step 2
Double-click the GNE.
Step 3
Complete the
Step 4
the GNE.
On the GNE, complete the
Step 5
address must be the IPv4 or IPv6 address of the NMS. For the UDP Port number, use the port number
on which the NMS is listening for traps. Use the user name configured in
tag name.
Step 6 Double-click the ENE.
Step 7 Complete the
the ENE.
Step 8 Complete the following tasks as required:
•
•
•
On the ENE, complete the
Step 9
target IP address should be the IP address of the GNE. The UDP port number is 161. Use the user name
configured in
Step 10 From the network view, click the Provisioning > SNMPv3 tabs.
Step 11 Complete the
page
The source of the trap must be the IP address of the ENE. For the Context Engine ID field, provide the
context engine ID of the ENE. Also, you need to specify the target tag defined in
incoming user details configured in
Stop. You have completed this procedure.
78-19416-01
This procedure describes how to manually configure the GNE/ENE to
allow an ENE to send SNMPv3 traps to the NMS.
None
NTP-H148 Verify Card and SFP Installation, page 3-2
Required if you want to implement SNMPv3 on your network.
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page 16-43
"DLP-H282 Create an SNMPv3 User" task on page 18-81
DLP-H285 Configure SNMPv3 Trap Destination, page
"DLP-H282 Create an SNMPv3 User" task on page 18-81
DLP-H284 Create Group Access, page 18-82
DLP-H283 Create MIB Views, page 18-82
DLP-H287 Create Notification Filters, page 18-85
"DLP-H285 Configure SNMPv3 Trap Destination" task on page
Step 7.
"DLP-H290 Manually Configure the SNMPv3 Proxy Trap Forwarder Table" task on
18-87.
Step 2.
to create a group on the ENE
to create a MIB view on the ENE
Step 7.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
on the node on which you want to set up
to create an SNMPv3 user on
18-83. The target IP
Step 4. Also, specify a target
to create an SNMPv3 user on
Step 5, and the
18-83. The
3-17