Ntp-H175 Enable Or Disable Autopm - Cisco ONS 15310-MA SDH Procedure Manual

Before You Begin

NTP-H175 Enable or Disable AutoPM

Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Click the Provisioning > Defaults tabs.
Step 2
In the Defaults Selector area, click NODE > General and choose NODE.general.AutoPM.
Step 3
In the Default Value field, select True to enable AutoPM.
Step 4
Click Apply.
Step 5
Follow Steps 1 through 5 to disable AutoPM. Select False in the Default Value field in Step 4 before
Step 6
proceeding to Step 5.
Stop. You have completed this procedure.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
7-6
This procedure allows you to enable or disable automatic autonomous
performance monitoring (AutoPM) reports.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page
Chapter 7
16-43. If you are already logged in, continue with
Monitor Performance
78-19416-01