Dlp-H285 Configure Snmpv3 Trap Destination - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 18 DLPs H200 to H299
Click Create.
Step 2
In the Create Group Access dialog box, enter the following information:
Step 3
•
•
•
•
Step 4 Click OK to save the information.
Step 5 Return to your originating procedure (NTP).

DLP-H285 Configure SNMPv3 Trap Destination

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > SNMP > SNMP V3 > Trap Destinations (V3) tabs.
Step 1
Click Create.
Step 2
In the Configure SNMPv3 Trap dialog box, enter the following information:
Step 3
•
•
•
78-19416-01
Group Name—The name of the SNMP group, or collection of users, who share a common access
policy.
Security Level—The security level for which the access parameters are defined. Select from the
following options:
– noAuthNoPriv—Uses a user name match for authentication.
AuthNoPriv—Provides authentication based on the HMAC-MD5 or HMAC-SHA algorithms.
–
AuthPriv—Provides authentication based on the HMAC-MD5 or HMAC-SHA algorithms.
–
Provides DES 56-bit encryption based on the CBC-DES (DES-56) standard, in addition to
authentication.
If you select authNoPriv or authPriv for a group, the corresponding user must be configured with an
authentication protocol and password, with privacy protocol and password, or both.
Views
– Read View Name—Read view name for the group.
– Notify View Name—Notify view name for the group.
Allow SNMP Sets—Select this check box if you want the SNMP agent to accept SNMP SET
requests. If this check box is not selected, SET requests are rejected.
Note SNMP SET request access is implemented for very few objects.
This procedure provisions SNMPv3 trap destination.
None
DLP-H29 Log into CTC, page 16-43
As needed
Onsite
Provisioning or higher
Target Address—Target to which the traps should be sent. Use an IPv4 or an IPv6 address.
UDP Port—UDP port number that the host uses. Default value is 162.
User Name—Specify the name of the user on the host that connects to the agent.
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
18-83