Ntp-H133 Modify Osi Provisioning - Cisco ONS 15310-MA SDH Procedure Manual

Chapter 10 Change Node Settings
•
•
•
•
•
•
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.

NTP-H133 Modify OSI Provisioning

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The "Management Network Connectivity" chapter of the Cisco ONS 15310-MA SDH Reference Manual
Note
includes additional information about the ONS 15310-MA SDH implementation of OSI.
Complete the
Step 1
Step 2.
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
•
•
•
•
•
•
78-19416-01
DLP-H40 Create a Static Route, page 16-55
DLP-H126 Modify a Static Route, page 17-34
DLP-H127 Delete a Static Route, page 17-34
DLP-H128 Disable Open Shortest Path First Protocol, page 17-35
DLP-H41 Set Up or Change Open Shortest Path First Protocol, page 16-56
DLP-H48 Provision a Firewall Tunnel, page 16-65
DLP-H129 Delete a Proxy Tunnel, page 17-35
DLP-H48 Provision a Firewall Tunnel, page 16-65
DLP-H130 Delete a Firewall Tunnel, page 17-36
"NTP-H102 Back Up the Database" procedure on page
This procedure modifies the ONS 15310-MA SDH OSI parameters
including the OSI routing mode, TARP, routers, subnets, and
IP-over-CLNS tunnels.
None
NTP-H131 Provision OSI, page 3-13
As needed
Onsite or remote
Provisioning or higher
"DLP-H29 Log into CTC" task on page
"NTP-H102 Back Up the Database" procedure on page
DLP-H201 Provision or Modify TARP Operating Parameters, page 18-2
DLP-H202 Add a Static TID to NSAP Entry to the TARP Data Cache, page 18-4
DLP-H203 Remove a Static TID to NSAP Entry from the TARP Data Cache, page 18-4
DLP-H204 Add a TARP Manual Adjacency Table Entry, page 18-5
DLP-H209 Remove a TARP Manual Adjacency Table Entry, page 18-9
DLP-H235 Change the OSI Routing Mode, page 18-38
DLP-H211 Edit the OSI Router Configuration, page 18-10
DLP-H212 Edit the OSI Subnetwork Point of Attachment, page 18-10
16-43. If you are already logged in, continue with
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
Before You Begin
14-2.
14-2.
10-3